volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting multifunction switchF125 > < Removing multifunction switchF125

Polo Mk5

Installing multifunction switchF125
Installing multifunction switch -F125-
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Install in reverse order of removal. During this step, observe the following:
  W00-0427
–  Place multifunction switch -4- on selector shaft -6-.
–  Tighten securing bolts -5- for multifunction switch hand-tight.
–  Bend back hooks of lock washer -2-.
–  Place washers -2- with hooks facing upwards and -3- on selector shaft -6-.
–  Tighten nut -1- to 7 Nm and secure by bending up hooks on lock washer -2-.
–  Renew securing clip if hooks have broken off.
  N38-10002
–  Place lever -3- on selector shaft -4-.
–  Now use lever -3- to select „N“ on gearbox. When doing this, push lever backwards onto stop against direction of normal travel.
–  Now engage „N“ on gearbox. To do this, push lever -3- two detent positions forwards in direction of normal travel.
–  Place spring clip -2- and nut -1- on selector shaft -4-.
–  Tighten nut -1- to 13 Nm.
–  Before ball head of cable is placed on selector shaft: check selector lever cable → Chapter.
–  Adjust selector lever cable after installing → Chapter.
–  Install battery with battery tray → Rep. gr.27.
–  Insert automatic gearbox control unit -J217- in bracket on battery carrier.
–  Check shift mechanism → Chapter.
  N38-10001

Adjusting multifunction switchF125 > < Removing multifunction switchF125