volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing clutch pedal, RHD

Polo Mk5

Removing
Removing
–  Remove mounting bracket with master cylinder → Chapter.
   
–  Release master cylinder operating rod from clutch pedal as follows:
–  Press sides of retainer inwards -arrows- using pliers -T10005- and pull gently on clutch pedal.
Clutch pedal with extension spring
–  Unhook extension spring. (Shown here with mounting bracket installed.)
  N30-0280
Right-hand part of figure -arrows- only applies to installation.
Clutch pedal with over-centre spring
  N30-10226
–  Press over-centre spring in -direction of arrow- and remove downwards.
Continuation for all
  N30-10255
–  Remove bearing shaft for clutch pedal.
–  To do this, turn bearing shaft for clutch pedal to left -direction of arrow-.
-1- = Allen key, 8 mm AF.
Locking devices -A- are irreparably damaged.
Pins -B- are then horizontal.
–  Remove bearing shaft and take off clutch pedal.
  N30-10227

Installing > < Removing and installing clutch pedal, RHD