Polo Mk5
| Dismantling and assembling output shaft 3 - overview |
| 1 - | Output shaft 3 |
| 2 - | Needle bearing |
| 3 - | Reverse gear synchromeshed gear |
| 4 - | Synchro-ring |
| 5 - | Locking collar and synchro-hub for reverse gear |
| q | Dismantling and assembling → Chapter |
| 6 - | Retaining ring |
| 7 - | Stop ring |
| 8 - | Parking lock gear |
| q | Smooth side points towards shaft end, »crowned« side towards reverse gear for synchromeshed gear |
| 9 - | Bearing |
| 10 - | Ball socket |
| q | Removing and installing → Chapter>>>>>>>> |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 11 - | Ball socket |
| q | Removing and installing → Chapter>>>>>>>> |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 12 - | Sleeve |
| q | Removal is not mandatory |
| q | Lift out with screwdriver |
| q | Press in by hand using locking pin -T10043- to stop |
| 13 - | Bearing |
