Polo Mk5
| Assembly overview - intake manifold |
| 1 - | 10 Nm |
| 2 - | Throttle valve module -J338- |
| q | Clean → Chapter. |
| q | 6-pin connector |
| q | Gold-plated contacts. |
| q | Heated by coolant. |
| q | If renewed, adapt engine control unit -J623- to throttle valve module → Vehicle diagnostic tester„Guided functions“ |
| 3 - | Gasket |
| q | Renew. |
| 4 - | Connection |
| q | from oil separator |
| 5 - | Connection |
| q | From activated charcoal filter system solenoid valve 1 -N80- |
| 6 - | Seal |
| q | Renew if damaged. |
| 7 - | 20 Nm |
| 8 - | 3 Nm |
| 9 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42-. |
| q | 4-pin connector |
| q | Gold-plated contacts. |
| 10 - | O-ring |
| q | Renew if damaged. |
| 11 - | 20 Nm |
| 12 - | O-ring |
| q | Renew if damaged. |
| 13 - | Intake manifold |
| q | Removing and installing → Chapter |
| 14 - | Intake connecting pipe |
