Removing and installing ignition coils with output stage
Removing and installing ignition coils with output stage
Removing and installing ignition coils with output stage
Special tools and workshop equipment required
t
Assembly tool -T10118-
t
Puller -T10094 A-
Note
The housings for ignition coils with output stages have been modified. As a result, puller -T10094 A- is required for removing these ignition coils. The previous puller -T10094- can continue to be used if processed as described in the following.
–
Remove marked area -2- using suitable workshop equipment to attain the new nominal dimension -B- of 18 mm.
–
Additionally identify the tool designation with the letter A -1-.
Removing
–
Fit puller -T10094 A- on ignition coil with final output stage -arrow-.
–
Pull ignition coil with final output stage out slightly.
–
Fit assembly tool -T10118- as shown.
–
Carefully release connector locking mechanism and pull off connector.
Installing
–
Fit puller -T10094 A- on ignition coil with final output stage.
–
Push connector onto ignition coil with final output stage until it audibly engages.
–
Press ignition coil with output stage into cylinder head in direction of -arrow-.