Pressing in sealing flange with sender wheel |
Note t
| The sealing flange with a PTFE seal is equipped with a sealing
lip support ring. This support serves as an assembly sleeve. The support
ring must not be removed before installation. |
t
| Sealing flange and sender wheel must not be separated or turned
after removal from packaging. |
t
| The sender wheel is held in its installation position on the assembly device -T10134- by a locating pin. |
t
| The sealing flange and seal are one unit. The unit can only
be renewed together with sender wheel. |
t
| The assembly device -T10134- is
held in its position relative to the crankshaft by a guide pin inserted
into a hole in the crankshaft. |
|
|
|