Polo Mk5
| Assembly overview - Lambda probe and exhaust gas temperature senders (Polo) |
| 1 - | Exhaust gas temperature sender 4 -G648- |
| q | Removing and installing → Rep. gr.26. |
| 2 - | Exhaust gas temperature sender 1 -G235- |
| q | Removing and installing → Rep. gr.26. |
| 3 - | Exhaust gas temperature sender 3 -G495- |
| q | Removing and installing → Rep. gr.26. |
| 4 - | Pressure differential sender -G505- |
| q | Removing and installing → Chapter. |
| q | 45 Nm |
| 5 - | Lambda probe -G39- with Lambda probe heater -Z19- |
| q | Removing and installing → Chapter. |
| q | New Lambda probes are coated with an assembly paste |
| q | In the case of a used Lambda probe, grease only the thread with high-temperature paste; high-temperature paste → Electronic parts catalogue |
| q | Assembly paste or high-temperature paste must not get into the slots in the Lambda probe |
| q | 55 Nm |
