volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Radiator, radiator fan > < Removing and installing coolant pump belt pulley (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet)

Polo Mk5

Removing and installing coolant circulation pumpV50 (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet)
   
Removing and installing coolant circulation pump -V50- (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet)
Special tools and workshop equipment required
t  Refractometer -T10007-
t  Hose clip pliers -VAS 6340-
t  Torque wrench -V.A.G 1331-

   
t  Hose clamps up to 40 mm -3093-
Removing
Golf Plus, Eos, Scirocco, Golf, Golf Cabriolet, Touran, Polo
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
Tiguan
–  Depending on vehicle equipment, remove noise insulation or skid plate → General body repairs, exterior; Rep. gr.50.
Continuation for all vehicles
–  Seal coolant hoses with hose clamps up to 40 mm -3093-.
  W00-0671
–  Remove spring-type clips -arrows- and pull coolant hoses off.
–  Pull connector -1- off and remove securing bolt -2-.
–  Remove coolant circulation pump -V50--3-.
Installing
Installation is carried out in the reverse order. When installing, note the following:
Specified torque for securing bolt: 10 Nm.
–  Check coolant level; replenish as necessary (Golf Plus, Eos, Scirocco, Golf, Golf Cabriolet, Touran, Tiguan) → Chapter.
–  Check coolant level; replenish as necessary (Polo) → Chapter.
  N19-10172

Radiator, radiator fan > < Removing and installing coolant pump belt pulley (Polo, Touran, Golf Plus, Eos, Tiguan, Scirocco, Golf, Golf Cabriolet)