POLO Mk5: 14L Turbocharged and Supercharged Engine Exhaust Turbocharger Supercharger Assembly
| Assembly overview - supercharger |
| 1 - | Housing with noise insulation |
| q | For noise insulation. |
| 2 - | Noise insulation |
| q | For intake air. |
| 3 - | Intake hose |
| q | Secure with spring-type clips. |
| 4 - | 7 Nm |
| q | Self-tapping bolt. |
| q | Securing bolt must only be tightened with a nut runner if nut runner speed is max. 500 rpm and a max. tightening torque of 7 Nm is set. |
| 5 - | 7 Nm |
| 6 - | 7 Nm |
| q | Self-tapping bolt. |
| q | Securing bolt must only be tightened with a nut runner if nut runner speed is max. 500 rpm and a max. tightening torque of 7 Nm is set. |
| 7 - | O-ring |
| q | Renew. |
| 8 - | Pressure pipe |
| 9 - | Noise insulation |
| 10 - | Housing |
| q | For noise insulation. |
| 11 - | Noise insulation |
| q | For charge air. |
| q | With seal. |
| q | Renew seal between supercharger and noise insulation. |
| 12 - | Pulley |
| q | For supercharger. |
| 13 - | 8 Nm |
| 14 - | Coolant pump with magnetic clutch for supercharger -N421- |
| 15 - | Poly V-belt |
| q | For supercharger. |
Caution
|
| 16 - | 23 Nm |
| 17 - | Tensioning element |
| q | For supercharger poly V-belt. |
| q | Relieve tension using 16 mm open-end spanner -T10241-. |
| q | Lock with locking pin -T10060 A-. |
| 18 - | 40 Nm + 1/4 turn (90°) further |
| q | To loosen and tighten securing bolt, counterhold supercharger shaft with spanner. |
| q | Renew. |
| 19 - | Supercharger |
| q | Removing and installing (Golf Plus, Eos, Scirocco, Golf, Touran, Polo, Sharan, Passat, Passat CC) → Chapter |
| q | Removing and installing (Tiguan with four-wheel drive) → Chapter. |
| 20 - | 25 Nm |
