volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Test data, spark plugs > < Removing and installing ignition coils with output stage

Polo Mk5

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
The engine speed sender -G28- is located on the sealing flange on the flywheel end of the crankcase.
   
Special tools and workshop equipment required
t  Hose clip pliers -VAS 6340-
t  Torque wrench -V.A.G 1331-
t  Guide pins -T10341-
t  Locking pin -T10060 A-
t  Allen key, long reach -T10370-

Removing
–  Remove compressor → Chapter.
–  Remove supercharger (Tiguan with four-wheel drive) → Chapter.
   
–  Pull off connector -1- from engine speed sender -G28-.
–  Remove gasket -2- from cylinder block and remove engine speed sender -G28- with socket -T10370-.
Installing
–  Install engine speed sender -G28- and tighten securing bolt to 5 Nm.
Further assembly is basically the reverse of the dismantling sequence.
  N13-10291

Test data, spark plugs > < Removing and installing ignition coils with output stage