Polo Mk5
| Parts of cooling system - coolant pump side |
| 1 - | Main drive toothed belt |
| q | Mark direction of rotation before removing. |
| q | Check for wear. |
| q | Do not kink. |
| q | Toothed belt routing → Fig.. |
| q | Removing, installing and tensioning → Chapter. |
| 2 - | Coolant pump |
| q | Check for ease of movement. |
| q | If damaged or leaking, renew complete. |
| q | Removing and installing → Chapter. |
| 3 - | 10 Nm |
| 4 - | Rear toothed belt guard |
| 5 - | Toothed belt guard upper part |
| 6 - | Toothed belt guard lower part |
| 7 - | Belt pulley |
| q | When installing note fixing arrangement. |
| q | Removing and installing poly V-belt → Chapter. |
| 8 - | Securing bolt |
| q | Observe tightening procedure → Chapter. |
| q | Renew. |
| q | Oil before installing. |
| q | Secure belt pulley against turning with counterhold -3415-. |
| q | Turning further can be done in several stages. |
| q | The turning further angle can be measured with a commercial protractor. |
| 9 - | 12 Nm |
| q | Renew. |
| 10 - | 20 Nm |
| 11 - | Crankshaft toothed belt pulley |
| q | When installing note fixing arrangement. |
