| Cylinder block, sealing flange |
Caution | The crankshaft must not be removed. Just loosening the main bearing caps will cause deformation of the cylinder block bearing pedestals. This deformation will cause a reduction of the bearing clearance. Even if the bearing shells are not renewed bearing damage could occur due to a different bearing clearance. |
| If the bearing cap bolts are loosened, the cylinder block must be renewed complete with the crankshaft. |
| Measuring the main bearing clearance is not possible with normal workshop equipment. |
|
| Tightening procedure for poly V-belt pulley securing bolt → Chapter. |
| Removing and installing drive plate → Chapter. |
Note | Please note the characteristics of crankshaft sealing flange flywheel end, of the assembly devices -T10017- and the assembly device -T10134- → Chapter. |
| Renewing crankshaft sealing flange flywheel end, vehicles with manual gearbox → Chapter. |
| Renewing crankshaft sealing flange flywheel end, vehicles with automatic gearbox → Chapter. |
|
|
|
