Polo Mk5
| Assembly overview - power steering box, left-hand drive vehicle |
| 1 - | Right track rod end |
| q | Marked “C”. |
| q | Checking: → Chapter. |
| q | Pressing off steering arm → Anchor. |
| q | Installation position → Chapter. |
| 2 - | Nut |
| q | 50 Nm |
| 3 - | Clamp |
| 4 - | Boot |
| q | Must not be twisted after adjusting toe. |
| q | Remove steering box to renew. |
| 5 - | Clamp |
| q | Renew. |
| q | Tightening → |
| 6 - | Bolt |
| q | 8 Nm |
| 7 - | Heat shield |
| q | Allocation → Electronic parts catalogue “ETKA”. |
| 8 - | Clamp with nuts |
| q | Renew if thread is damaged. |
| 9 - | Rubber bush |
| 10 - | Right track rod |
| q | 80 Nm |
| q | Removing and installing → Chapter. |
| q | Replacement parts are supplied pre-adjusted. |
| q | Adjusting toe → Chapter. |
| 11 - | Power steering box |
| q | Allocation → Electronic parts catalogue “ETKA”. |
| q | Removing and installing → Chapter. |
| 12 - | Seal |
| q | Allocation → Electronic parts catalogue “ETKA”. |
| 13 - | Seal |
| 14 - | Power steering sensor -G250- |
| q | Removing and installing → Chapter. |
| q | Can be tested in “Guided fault finding” using -VAS 5051- |
| 15 - | Bolt |
| q | 6 Nm |
| 16 - | Left track rod end |
| q | Marked “D”. |
| q | Checking: → Chapter. |
| q | Pressing off steering arm → Anchor. |
| 17 - | Left track rod |
| q | 80 Nm |
| q | Removing and installing → Chapter. |
| q | Replacement parts are supplied pre-adjusted. |
| q | Checking length and adjusting → Chapter. |
