| If measured values are outside specified tolerances, this may be because the vehicle is inclined. |
| Right-hand drive vehicles or e.g. vehicles with an automatic gearbox may lean to one side slightly. |
| This is due to the installation position of the assemblies and their associated weight transfer and is normal. |
| –
| In such cases it is essential to measure dimension -a- at the rear on both sides. |
| –
| Correct any differences as required. |
| On the front axle, compensate by adding weights to the top of the respective suspension turret. |
| On the rear axle, compensate by adding weights to the respective side of the luggage compartment. |
| Sand-filled sacks (weighing approx. 10 kg) are suitable for this. |
|
|
|
