Charging battery in support mode with battery charger -VAS 5903- |
The support mode provides the onboard supply with power when the battery is removed or disconnected. |
The support mode is suitable in the following situations: |
t
| Support mode of onboard supplies without installed battery |
t
| Power conservation when renewing the battery |
t
| Ancillaries test without battery |
WARNING Danger of injury! Observe warning notices and safety regulations → Chapter! |
|
WARNING It is not permissible to test or charge batteries whose magic eye shows light yellow. Do not slave/jump start the vehicle! |
Danger of explosion when checking and charging or slave/jump starting. |
These batteries must be renewed. |
|
–
| Switch off ignition and all electrical consumers. |
Caution t
| The terminal polarity protection in operating mode „charging totally discharged batteries/support mode“ is not active. Connect battery charger terminal clamps correctly to battery terminals. |
t
| It can cause sparks through a short-circuit. |
t
| Ensure charger terminal clamps are seated securely. |
t
| Do not press START / STOP button when charger unit cables are connected incorrectly. The charger unit may be damaged. |
|
–
| Connect charger plug to battery charger. The last selected operating mode will appear on display → Chapter. |
Caution When battery is removed, ensure there is no contact between terminal clamp connected to positive clamp and body earth. Also ensure there is no contact between battery clamps. |
|
–
| Connect red terminal clamp „+“ to positive terminal of vehicle. |
Note In vehicles with start/stop function and battery monitor control unit -J367- fitted, black terminal clamp must be connected to body earth. Connecting it to battery negative terminal will cause start/stop system to malfunction. |
–
| Connect black terminal clamp „+“ to negative terminal of vehicle. |
–
| Press START / STOP for approx. 5 seconds. The menu „charging totally discharged batteries/support mode“ will be activated. |
–
| Press respective button „Up“↑ or „Down“↓ to set respective battery voltage (6 V, 12 V or 24 V). |
Note If a button is not pressed within 5 seconds the charger will return to the main menu (select operating mode). |
–
| Confirm the selected battery voltage with START / STOP. |
Then follows the enquiry for "is charger cable terminal polarity correct". |
–
| Check polarity of charger unit cables. |
–
| Confirm polarity of charger unit cables with START / STOP. |
The battery charger starts with support mode. |
End battery support mode: |
–
| Disconnect black terminal clamp „-“ of charger unit from negative terminal of vehicle. |
–
| Disconnect red terminal clamp „+“ of charger unit from positive terminal of vehicle. |
–
| Pull charger plug out of battery charger. |
|
|
|