R32 4Motion V6-3.2L (CBRA) (2008)
Installing
-
Installation is performed in the reverse order of removal.
NOTE: Before installing, check securing clips for damage and replace if necessary.
Wheel Housing Trim, 4 Door
Wheel Housing Trim, 4 Door
NOTE: Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the
same manner.
Removing
-
Remove rear seat bench
-
Remove 4-door side upholstery:
-
with rear side airbags
-
without rear side airbags
-
Remove the two bolts - 1 - (1.2 Nm).
-
Remove clip - 2 - from body flange.
-
Pull trim - 3 - from door seal tubing - 4 -.
-
Pull trim out of mounts in sill panel trim - 5 -.
-
Pull out trim in direction of travel under C-pillar trim panel.