R32 4Motion V6-3.2L (CBRA) (2008)
/Page-2027002.png)
-
Raise low beam reflector - 2 - slightly and rotate Headlamp Beam Adjusting Motor - 1 - in - direction of arrow - as far as stop.
-
Raise low beam reflector slightly and pivot positioning motor ball head - 1 - so that it can slide back in - direction of arrow - out of ball head
mount - 2 -.
-
Remove Headlamp Beam Adjusting Motor from headlamp while being careful of connected wires.
-
Disconnect connector - 1 - and remove Headlamp Beam Adjusting Motor - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Place connector - 1 - in Headlamp Beam Adjusting Motor - 2 -.
