R32 4Motion V6-3.2L (CBRA) (2008)
-
Press retaining tab - arrow - in direction of arrow with a suitable screwdriver and remove license plate lamp from bumper.
-
Disengage and disconnect harness connector - arrow -.
License plate lamp, installing:
Installation is the reverse of removal, noting the following:
NOTE: On the lens of the license plate lamp a small silver-colored glare-blocking strip - arrow - is applied. When installing the lens, this must always
face toward the bumper.
When assembling license plate lamp, make sure that diffusion lens gasket has proper fit.
-
Tighten the mounting bolts - arrows - to 1.2 Nm.