R32 4Motion V6-3.2L (CBRA) (2008)
^
If the bevel box is filled correctly, oil should leak out from the adapter -A-.
^
If no oil is escaping, lower vehicle and perform filling procedure again.
-
Raise vehicle.
-
If oil is escaping, place an oil container under the Haldex clutch (for example, on a workshop cart).
Overflowing oil now rungs back into oil container.
-
If no more oil runs back, remove charging device F/Haldex 2 coup. VAS 6291.
-
Finally, check the oil level in the Haldex clutch.
-
Insert the bolt -arrow- with a new seal and tighten to 15 Nm.