R32 4Motion V6-3.2L (CBRA) (2008)
/Page-1286011.png)
-
Wrap repair points with yellow adhesive tape to mark a performed repair.
Wire Break With Single Repair Point
Wire Break With Single Repair Point
Repair point with single crimp connection
-
Free up wire intended for repair (approximately 20 cm to both sides of repair point).
-
If required, remove wiring harness wrapping using a folding knife.
-
Cut out the damaged wire section using wire stripper VAS 1978/3.
NOTE: If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp
connection, insert a repair wire section of matching length with two crimp connections.
-
Strip wire ends using 6 - 7 mm wire stripper.
