R32 4Motion V6-3.2L (CBRA) (2008)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor 2
Fuel Level Sensor 2
Special tools, testers and auxiliary items required
-
Wrench T10202
-
Torque wrench V.A.G 1332
Removing
-
Fuel tank may be a maximum of 3/4 full.
NOTE:
-
Empty the fuel tank if necessary using the fuel extracting device VAS 5190.
-
Read safety precautions before beginning work.
-
Observe the rules for cleanliness.
-
Remove seat bench.
-
Remove left cover (when viewed from direction of travel) from fuel level sensor 2 G169
-
Disconnect electrical harness connectors.
-
Open locking ring using wrench T10202.
-
Pull fuel level sensor 2 G169 up slightly and unclip suction jet pump.
CAUTION: Do not bend the fuel level sensor 2 G169 floater arm when removing.
Installing
CAUTION: Do not bend the fuel level sensor 2 G169 floater arm when installing.
-
Insert fuel level sensor 2 G169 in fuel tank.