R32 4Motion V6-3.2L (CBRA) (2008)
Camshaft Position Sensor: Testing and Inspection
Camshaft Position Sensor 2 G163, Checking
Camshaft Position Sensor 2 G163, Checking
NOTE: Use only gold-plated terminals when servicing terminals in harness connectors of Camshaft Position (CMP) Sensor 2 G163.
Special tools, testers and auxiliary items required
-
Multimeter.
-
Wiring diagram.
Test requirements
-
The Engine Control Module (ECM) J623 fuses OK.
-
Battery voltage at least 12.5 volts.
-
All electrical consumers such as, lights and rear window defroster, switched off.
-
Vehicles with automatic transmission, shift selector lever into position "P" or "N".
-
A/C switched off.
-
Ground (GND) connections between engine/transmission/chassis OK.
-
Ignition switched off.
Test procedure
-
Perform a preliminary check to verify the customers complaint. See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing
and Procedures/Preliminary Check
Start diagnosis
-
Disconnect the Camshaft Position (CMP) Sensor 2 G163 electrical harness connector - 2 -.
-
Switch the ignition on.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor 2 G163 electrical harness connector terminals 1 to 3 for voltage.
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was obtained:
-
Replace Camshaft Position (CMP) Sensor 2 G163.
If the specification was not obtained: