R32 4Motion V6-3.2L (CBRA) (2008)
-
Replace O-rings -1- and -2-.
-
Note different diameter:
^
Inner diameter O-ring -1- = 11 mm
^
Inner diameter O-ring -2- = 12 mm
-
Replace O-ring -arrow A- at pressure sensor.
Note: The marking -arrow B- on the convex side of the plate spring -2- faces up and toward the pressure sensor -1- in installation location.
-
Place plate spring -2- with convex side on pressure sensor -1-.
-
Place the new cover -5- on the control module -6-.
-
Insert pressure sensor -4- with plate spring in new cover -5- and press onto connector. Convex side of plate spring faces toward pressure sensor.
-
Lightly coat new pressure sensor -4- O-ring with high performance Haldex clutch oil.
-
Insert valve -1- in new cover -5- and control module -6- and press onto connector.
-
Lightly coat new O-rings -2- and -3- with high performance Haldex clutch oil.