R32 4Motion V6-3.2L (CBRA) (2008)
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specification was obtained:
Checking Ground (GND) activation
If the specified value was not obtained:
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) J623.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) G130 electrical harness connector to the
Engine Control Module (ECM) J623 electrical harness connector T121 for resistance.
Oxygen Sensor (O2S) Behind
Engine Control Module (ECM)
Three Way Catalytic Converter
J623 electrical connector T121
(TWC) G130 electrical harness
terminal or test box socket
connector terminal
2
63
Specified value: 1.5 ohms max.
If the specification was not obtained:
-
Check the wiring for an open circuit, a short circuit to each other, Battery (+), or Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and if the voltage supply was OK:
-
Erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes
-
End diagnosis.
If the DTC returns and no malfunction is found in the wiring and the voltage supply was OK:
-
Replace the Engine Control Module (ECM) J623.
-
Assembly is performed in the reverse of the removal.
Final procedures
After repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory