R32 4Motion V6-3.2L (CBRA) (2008)
Stabilizer Bar: Removal and Replacement
Stabilizer Bar
Special tools, testers and auxiliary items required
^
Locating pins T10096
^
Torque Wrench V.A.G 1332
^
Engine/transmission jack V.A.G 1383 A
^
Ball joint puller 3287 A
Removing
-
Remove front wheels.
-
Remove foot well trim, remove nuts -arrows- to do so.
-
Remove bolt -1- and pull off universal joint -2- from steering gear.
-
Remove lower noise insulation.
-
Remove coupling rods from stabilizer.
-
Remove nuts -arrows-.
-
Loosen tie rod end nut on both sides, but do not remove yet.
To protect thread, screw nut on pin a few turns.