R32 4Motion V6-3.2L (CBRA) (2008)
10 - Protective cap
Suspension Strut
Suspension Strut
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1332
^
Spreader 3424
^
Engine/transmission jack V.A.G 1383 A
^
Mount T10149
Removing
-
Loosen drive axle bolt to wheel hub.
Note: When doing this, vehicle must not stand on wheels, otherwise wheel bearing may be damaged.
-
Remove wheel.
-
Remove coupling rod hex bolt -arrow- from suspension strut.
-
Disengage wire for wheel speed sensor from suspension strut.
-
Remove nuts -arrows-.
-
Pull wheel bearing housing with ball joint out of control arm.
-
Pull drive axle outer joint out of wheel hub.
-
Secure drive axle to body using wire.
CAUTION! Drive axle must not hang down, otherwise inner joint may be damaged when bent too far.
-
Bolt ball joint onto control arm again.