R32 4Motion V6-3.2L (CBRA) (2008)
/Page-1403003.png)
^
Do not turn more than 90° right or left (that is smallest to largest possible adjustment)
2 - Nut
^
M12 x 1.5
^
95 Nm
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
3 - Eccentric washer
^
Inner bore with tab
4 - Eccentric bolt
^
After loosening, perform vehicle alignment
^
Do not turn more than 90° left or right (that is, smallest to largest possible adjustment)
5 - Eccentric washer
^
Inner bore with tab
6 - Nut
^
M12 x 1.5
^
95 Nm
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
Note:
^
Adjust torque wrench V.A.G 1332 to 80 Nm when tightening nut.
^
This torque specification applies only in conjunction with insert Tool 18 mm T10179.
7 - Subframe
8 - Bolt
^
M12 x 1.5 x 125
^
90 Nm plus an additional 90° turn
^
Always replace after removal
9 - Lower transverse link
10 - Nut
^
M12 x 1.5
^
90 Nm plus an additional 90° additional turn
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
11 - Bolt
^
Always replace after removal
12 - Threaded rivet
^
M6
13 - Expanding rivet
14 - Stone protection plate
15 - Bolt
^
8 Nm
16 - Nut
^
M14 x 1.5
^
130 Nm plus an additional 90° turn
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
17 - Bolt
^
Always replace after removal
^
Always tighten bolts in curb weight position
18 - Upper control arm
19 - Washer
20 - Nut
^
M14 x 1.5
^
130 Nm plus an additional 90° turn
^
Self-locking
^
Always replace after removal
21 - Wheel Bearing Housing
^
A mixed installation of aluminum wheel bearing housings is permissible
^
Only aluminum wheel bearing housing are available as a replacement part; therefore when exchanging, there are certain parts which must be
exchanged and/or additionally installed.
22 - Washer
