R32 4Motion V6-3.2L (CBRA) (2008)
Shifter A/T: Procedures
Shift Mechanism Overview
Shift Mechanism Overview - 02E, 6 Speed DSG A/T AWD
1 - Shift cover with knob
^
The cover is unclipped for emergency release.
^
Before removing the handle, pull the button out past its pressure point and secure with cable ties or wire
^
Do not press the button in. Otherwise, the handle will have to be disassembled and prepared for installation with the button pressed in.
2 - Selector lever and selector mechanism
^
With Shift Lock Solenoid N110
^
Short description for removal and installation:
-
Remove center console.
-
Remove cable from transmission.
-
If necessary: Disconnect or remove.
-
Remove heat shield at bottom of vehicle.
-
Adjust selector lever cable after installing.
3 - Bolt with spring
^
3 Nm
4 - Pin
^
Do not grease
5 - Securing plate
^
Always replace after removal
6 - Nut
^
9 Nm
^
Quantity: 4
7 - Shift housing
^
With seal
8 - Lock washer
^
Always replace after removal
9 - Lock washer