R32 4Motion V6-3.2L (CBRA) (2008)
-
Replace O-rings -C- of oil cooler -B-.
-
Set oil cooler -B- in place, observing the O-rings -C-.
-
Screw in new bolts -A- and tighten to 20 Nm + 90° (1/4 turn).
-
Install coolant hoses on oil cooler and remove Hose clamps 3094.
-
Insert the new filter with the seat facing down and tighten the housing to 20 Nm.
-
Install battery and battery holder.
-
Check coolant level and top off coolant if necessary.
-
Fill oil after the repair without changing the filter.
CAUTION! Do not start the engine while checking the coolant level because no DSG oil has been added.