R32 4Motion V6-3.2L (CBRA) (2008)
Note Location of Various Collar Screws
Ensure CV joint/driveshaft markings -arrow A- and -arrow B- align.
-
Tighten the front driveshaft tube to the rear driveshaft tube -arrows-.
Install the Center Bearing Without Tension
^
All driveshaft bolts are tightened.
-
Align the center bearing in its elongated holes so the driveshaft or bearing is not under stress.
When fastening the heat shield -2- to the center bearing, ensure the combination bolts -1- lie inside the four centering tabs.