Rabbit L5-2.5L (BGP) (2006)
-
Remove locking pin T40069 and install screw plug - 1 - on cylinder block at rear.
The rest of installation follows reverse of removal procedures.
Tightening torque
Secure crankshaft for checking/adjusting valve timing
-
Remove cylinder head cover.
-
Perform work steps for "Secure crankshaft".
Note:
^
If threaded holes in camshafts - arrows - do not stand upward, crankshaft must be rotated one rotation (360°) in direction of engine rotation.
In order to be able to precisely check and adjust valve timing, always note the following:
^
Turn crankshaft only in direction of engine rotation - arrow -. Do not rotate crankshaft back, not even slightly!