Rabbit L5-2.5L (BGP) (2006)
-
Disconnect the electrical harness connector - 2 - from the Throttle Valve Control Module J338.
Checking resistance
-
Using a Multimeter, check the resistance of Throttle Drive (for Electronic Power Control (EPC)) G186 at Throttle Valve Control Module J338
between terminals 3+5.
Specified resistance 4.0 Ohms max.
If the specification is not obtained:
-
Replace Throttle Valve Control Module J338.
If the specification is obtained:
Checking voltage supply and wiring
-
Switch ignition on.
-
Using the Multimeter, check the voltage of Throttle Drive (for Electronic Power Control (EPC)) G186 at Throttle Valve Control Module J338
between terminals 2+6.
Specified value: at least 4.5 V
-
Switch ignition off.