Rabbit L5-2.5L (BGP) (2006)
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J623. Refer to ADD LINK.
-
Using a Multimeter, check the Selector Lever E313 electrical harness connector to the Motronic Engine Control Module (ECM) J623 electrical
harness connector 194 for resistance.
Selector Lever E313
Motronic Engine Control Module (ECM) J623
electrical harness connector
electrical connector T121 terminals or test
terminals
box sockets
8 (Can_Bus Low)
58
7 (Can_Bus High)
60
Specified value: 1.5 Ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Selector Lever E313.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03: Interrogating Fault Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased, generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
End of diagnosis.