Rabbit L5-2.5L (BGP) (2006)
NOTE: For the removal of base carrier for steering column switches -2-, shear bolts of steering lock housing must be drilled out. New shear bolts -1-
are required for the subsequent installation Parts Catalog (ETKA).
CAUTION:
-
Before drilling out shear bolts, always make sure that components secured to base carrier are removed beforehand.
-
By drilling out, drill shavings can reach the neighboring components, which can lead to damage and / or malfunctions.
-
Follow the specified sequence when removing the components.
Removing:
-
Disconnect battery.
CAUTION: When disconnecting and connecting battery, the procedure must be followed as described.
Remove the following components in order:
-
Remove steering wheel.
-
Remove steering column trim.
-
Remove Steering Column Electronic Systems Control Module J527.
-
Remove Airbag Spiral Spring/Return Spring With Slip Ring F138.
-
Remove Steering Angle Sensor G85.
-
Remove Turn Signal switch E2.
-
Remove Windshield Wiper Switch E.
-
Disconnect harness connector -arrow- at induction coil -3-.
After components secured to base carrier have been removed, the base carrier can be removed:
-
Drill out mounting bolts -1- for steering lock housing -3-.
NOTE: Bolts M8 -1-, core hole diameter 6.8 mm.
-
Remove steering lock housing and base carrier for steering column switches -2- from steering column toward rear.
-
Remove steering lock housing from base carrier for steering column switches.
Installing:
-
Set steering lock housing in base carrier for steering column switches.
-
Slide base carrier for steering column switches -2- as far as possible onto steering column.
-
Connect harness connector -arrow- to induction coil -3-.
-
Bolt steering lock housing to steering column with new shear bolts -1-.
-
Tighten shear bolts -1- until bolt heads shear off.
-
Install all components in reverse order of removal.