Rabbit L5-2.5L (BGQ) (2008)
Drive Belt: Service and Repair
Ribbed Belt
Ribbed Belt
Special tools, testers and auxiliary items required
^
Drift T10060A
Ribbed belt, removing
-
Remove noise insulation.
-
Remove front part of right front wheel housing liner.
Remove ribbed belt for A/C compressor
-
Mark direction of rotation of ribbed belt.
-
Swivel tensioning element - 1 - as depicted using a 15 mm open end wrench - A - in direction of - arrow - and secure using drift T10060A.
-
Remove ribbed belt for A/C compressor.
Remove ribbed belt for generator and coolant pump.
-
Relieve tension of tensioning element - 1 - for A/C compressor ribbed belt (pull out drift T10060A).
-
Mark running direction of ribbed belt for generator and coolant pump.
-
Insert drift T10060A into tensioning element - 2 -.
-
Swivel tensioning element - 2 - using a 15 mm open end wrench - A - in direction of - arrow - and secure using drift T10060A.
-
Remove ribbed belt for generator and coolant pump.
Ribbed belt, installing
Installation is in reverse order of removal, note the following: