Scirocco L4-1715cc 1.7L SOHC (1983)
Window Regulator: Customer Interest
Power Window - Inoperative
Subject:
Inoperative Power Window
Model(s): Scirocco
Group:
64
Number:
64-90-T03
Date:
May 31, 1990
The power window becomes inoperative if the winder mechanism locks up in the end position of travel (window closed).
To repair a window regulator, use the following parts and procedure. Always modify the regulators in both doors to prevent recurrence of the problem.
Parts required:
1 reinforcement plate, P/N 533 837 493 1 each screws, P/N N014 1405 and N014 1444 2 lock washers, P/N N011 6663 2 bushings, supplied by dealer.
Bushings are made from 20 mm (3/4") thick round steel stock, cut to 10 mm (7/8") wide with a 6 mm (1/4") hole in the center. See illustration.
Repairing Window Regulators:
-
Remove door panel and carefully remove vapor barrier.
-
Operate window switch in downward position while an assistant pushes down on the glass (motor will take over and complete lowering of
window glass).
CAUTION: DO NOT TAP MOTOR. Damage to the motor magnets could result from such attempts to get the motor to run.
