Scirocco L4-1781cc 1.8L DOHC (1986)
-
prepare spacer tubes (as shown) from segments of rubber hose A = 10 mm (.39 in.) B = 50 mm (1.97 in.)
CAUTION
Part numbers are for reference only. Always check with your Parts Department for latest information.
-
affix adhesive tape and spacer tubes as shown
Note
To insure proper adhesion, wheel house molding must fit tight to fender.
-
place spacer tubes on spoiler edges to eliminate buckling
^
clean off excessive adhesive with 3M General Purpose Adhesive Cleaner or equivalent
-
reinstall bumper
-
reinstall radiator grille, if applicable
CAUTION
Allow adhesive to set for 10 hours before removing tape.
Do not run vehicle through automatic car wash for next 24 hours.
