Scirocco L4-1781cc 1.8L DOHC (1986)
Timing Belt: Service and Repair
Removal
Camshaft Drive Belt & Cover
-
The camshaft drive belt and its related parts are shown in the image above. Although no maintenance interval is specified, periodic inspection of
the belt, and replacement at 60,000 to 75,000 miles (96,000 to 120,000 km), or every 4 to 5 years is recommended.
-
Removal of the belt is the best way to perform a thorough inspection.
TO REMOVE AND INSPECT CAMSHAFT DRIVE BELT:
1. Remove the socket-head shouldered nut securing the upper camshaft drive belt cover, and remove the cover.
2. Loosen the coolant pump pulley bolts, and remove the V-belts. Remove the coolant pump pulley.
Crankshaft Timing Marks On Vibration Damper & Lower Drive Belt Cover
3. Using a socket wrench on the crankshaft vibration damper bolt, rotate the engine by hand to set the No.1 cylinder at Top Dead Center (TDC).
NOTE: Check the position of the distributor rotor or the flywheel ignition timing marks to confirm cylinder No.1 TDC. The vibration damper
mark alone could indicate TDC for cylinder No.1 or No.4.
