Scirocco L4-1781cc 1.8L DOHC (1986)
Fig. 6 Speedometer drive gear, installing
Final Drive, Adjusting
When reusing bearings, intermediate gear shaft and differential adjusting ring should be set to marks made before removing.
When replacing differential housing or it bearings are to be reused, measure effective turning torque (see page 39.22) before disassembling
Following instructions apply only if bearings are replaced.
-
install bearing outer race in housing
-
install bearing outer race in one-way clutch support (without shim)
-
install drive shaft and one-way clutch support
-
position end plate and dial gauge holder and zero dial gauge with no preload
