Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
-
Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit Part No. 1H0 698 311 A.
-
Remove the nuts - arrows - and remove foot well trim - 1 -.
-
Remove the noise insulation on the brake pedal, if applicable - 3 - => [ Noise Insulation on the Brake Pedal ] See: Brake Pedal Assy/Service and
Repair/Brake Pedal Assembly Overview.
-
Disconnect brake pedal from brake booster. Refer to => [ Brake Pedal and Brake Booster ] See: Brake Pedal Assy/Service and Repair/Brake Pedal
and Brake Booster.
-
Remove the nuts - 1 - from brake booster.
-
Loosen both upper nuts - 2 - from the mounting bracket.
-
Carefully remove brake booster from vehicle.
-
Remove the nuts for the brake master cylinder.
-
Carefully remove the brake master cylinder from the brake booster.
Installing
-
Installation is in reverse order of removal.
Observe the following points when installing:
-
Make sure the boot is installed correctly.