Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Dashboard / Instrument Panel: Procedures
Instrument Panel, Aligning in Vehicle
Instrument Panel, Aligning in Vehicle
It is not necessary to change instrument panel position to increase horizontal gap between door trim and instrument panel.
-
Hold an appropriately thick cloth at left edge of instrument panel and close door.
In this way, door trim engages closer to door and the gap between door trim and instrument panel increases appropriately. Thus, it is not necessary to
align instrument panel.
‹› Perform work on passenger side in the same way.
Instrument panel, aligning
Instrument panel can be aligned in height and diagonally to direction of travel.
-
Remove the wiper arms
-
Remove the left plenum chamber cover
-
Remove side instrument panel covers => [ Instrument Panel ] See: Removal and Replacement/Instrument Panel
-
Remove the heat and A/C controls trim => [ Heater and A/C Controls Trim ] See: Heating and Air Conditioning/Control Assembly/Service and
Repair/Heater and A/C Controls Trim
-
Loosen the bolts - 1 - and - 2 - under the heater and air conditioning controls 2 to 3 turns (2.5±0.5 Nm).
-
Remove the trim on both sides of the footwell => [ Footwell Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Footwell Trim
-
Loosen the screw - 1 - in the plenum chamber 2 to 3 turns (20 Nm).