Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
-
Now place (V.A.G 1383 A) under wheel bearing housing.
-
First press off ball joint from control arm in order to then pull off the wheel bearing housing from suspension strut.
Installing
Installation is the reverse of removal, with special attention to the following:
If a wheel bearing housing was replaced, vehicle must be aligned. Refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel
Alignment.
-
Install wheel and tighten. Refer to => [ Tightening Specification for Mounting Wheels ] See: Wheel Fastener/Specifications.
Tightening Specifications
Wheel Bearing Housing
All Wheel Drive (AWD)
Wheel Bearing Housing
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)