Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
1. Nut (3346/3)
2. (3346)
3. Bonded rubber bushing
4. (3378)
5. Nut, commercially available
6. Spindle (3346/2)
-
Install bonded rubber bushing by turning support arm bearing installation tool.
‹› Do not use lubricant!
‹› Insert bearing with care so it is not canted.
-
Install cover plate.
-
Install wheel bearing/wheel hub unit.
‹› Bolting at wheel bearing housing may occur only when dimension " a" has been obtained! Refer to => [ Measure Dimension ] See: Steering and
Suspension/Suspension/Service and Repair/Removal and Replacement/Rear Suspension.
-
Tighten bolt - arrow - for lower transverse link - 1 -.
-
Install coil spring. Refer to => [ Coil Spring ]. See: Steering and Suspension/Suspension/Service and Repair/Removal and Replacement/Rear