Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Ignition Switch: Service and Repair
Ignition Switch and Lock Cylinder, Through 05.10
Ignition Switch and Lock Cylinder, Through 05.10
=> [ Steering Lock Housing ]
=> [ Lock Cylinder ]
=> [ Ignition Switch ]
=> [ Ignition Switch Key Lock Solenoid ]
Steering Lock Housing
CAUTION!
When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
CAUTION!
‹› Steering lock may be destroyed.
‹› If steering lock is operated without lock cylinder, it locks and must be replaced.
‹› Steering lock must not be operated without lock cylinder.
‹› To remove the steering lock housing, remove the steering column switch base carrier first.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery,
Disconnecting and Connecting.
-
Remove the steering column switch base carrier, refer to => [ Steering Column Switch Base Plate ] See: Accessories and Optional
Equipment/Steering Mounted Controls Communication Module/Service and Repair/Steering Column Switches, Through 05.10.
Lock Cylinder
CAUTION!
‹› When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
‹› Steering lock may be destroyed.
‹› If steering lock is operated without lock cylinder, it locks and must be replaced.
‹› Steering lock must not be operated without lock cylinder.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery,
Disconnecting and Connecting.
-
Remove the steering wheel.
-
Remove steering column trim.
‹› The illustration does not show the turn signal switch, windshield wiper switch, steering angle sensor, spiral spring and steering column electronic
systems control module. Components must not be removed when removing lock cylinder.
‹› The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.
‹› To improve clarity, the ignition key is not shown in the following illustrations.
-
Insert ignition key into lock cylinder and turn it into position Drive.