Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Seat Occupant Sensor: Service and Repair
Passenger Occupant Detection System Repair Kit, Installing
Passenger Occupant Detection System Repair Kit, Installing
‹› When installing, there must be no wiring harness of seat heater between upholstery and mat for seat occupied recognition.
‹› Pressure hose must be routed without kinking.
‹› Stickers with notes on harness connectors must not be damaged.
‹› After vehicle was connected to electrical system, check replaced components for freedom of movement by moving seat.
After replacing seat occupied recognition, basic setting of seat occupied recognition must be performed using diagnostic tester containing "Guided
Fault Finding" => [ Seat Occupied Recognition, Performing Basic Setting ] See: Air Bag Systems/Testing and Inspection/Component Tests and
General Diagnostics.
CAUTION!
Basic setting must be performed when seat is not occupied.
Installation is reverse of removal, noting the following:
CAUTION!
Seat cushion, mat for seat occupied recognition, pressure hose, Seat Occupied Recognition Pressure Sensor (G452) and Seat Occupied
Recognition Control Module (J706) must not be separated!
-
Switch on ignition.
CAUTION!
Make sure that no persons are in the vehicle.
-
Connect vehicle battery.