Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-128002.png)
Specified value: near 5.0 V
-
Switch the ignition off.
If the specified value was Not obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J623). Refer to the Repair Information.
-
Using a multimeter, Check the Camshaft Position (CMP) Sensor (G40) electrical harness connector to the Motronic Engine Control Module
(ECM) electrical harness connector T60 for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was Not obtained:
