Touareg V10-5.0L DSL Turbo (BKW) (2004)
Rear Subframe Mount: Service and Repair
Subframe Bonded Rubber Bushing
-
Before replacing faulty bushing, check the others as well.
If tears and damages are visible, they must also be replaced.
Special tools, testers and auxiliary items required
‹› Engine and transmission jack (VAG 1383 A)
‹› Kukko support (kukko 22-2)
‹› Kukko extractor (kukko 21/4)
‹› Kukko separating tool (kukko 15-2)
‹› Hydraulic press (VAS 6178) with pressure head (T10205/13)
‹› Tensioning strap (T10038)
‹› Hollow piston cylinder (VAS 6179)
‹› Torque wrench (VAG 1332)
‹› Assembly tool (T10301)
CAUTION!
Before starting work, stabilizer bars must be coupled in vehicles with separable stabilizer bars. Otherwise, there is the danger of injury
caused by unintentional separation.
-
Depressurize hydraulic system for separable stabilizer bars using the.
-
Remove wheels.
-
Secure exhaust system on subframe, as depicted in illustration, using tensioning strap (T10038).
-
Remove rear part of exhaust system:
-
Disconnect all electrical wires from body to axle.
With Separable Stabilizer Bar
-
Remove left rear wheel housing liner.
-
Disconnect both hydraulic lines - 1 - and electrical connection - 2 -.