Touareg V10-5.0L DSL Turbo (BKW) (2004)
/Page-2352013.png)
‹› Secure to stabilizer bar using clamp.
7
Stabilizer bar mount
Installation position:
‹› Mark on stabilizer bar before removing.
‹› Large outer diameter must point outward.
8
Stabilizer bar mount
Installation position:
‹› Mark on stabilizer bar before removing.
‹› Large outer diameter must point outward.
9
Clamp
‹› Installation position, refer to --> [ Installation Position of Clamp for Mounting of Hydraulic Lines at Separable Stabilizer Bar ]
10
Rear axle stabilizer decoupling sensor (G485)
‹› Can be tested in "Guided Fault Finding" using the vehicle diagnosis, testing and information system (VAS 5051).
11
Bolt
‹› 3 Nm.
12
Seal
‹› Always replace after removal.
Installation Position of Clamp for Mounting of Hydraulic Lines at Separable Stabilizer Bar
‹› Clamp fastener - 1 - must be beneath bracket - 2 -. From this it follows that the clamp is tightened from below.
‹› Clamp must directly make contact at bracket - 2 - - arrow -.
Separable Stabilizer Bar Line Routing
Separable Stabilizer Bar Line Routing
The - arrow - points in driving direction.
