Touareg V10-5.0L DSL Turbo (BKW) (2004)
‹› Installation position: Colored marking on front driveshaft must line up with colored marking on front final drive.
5
Transfer case
6
Nut
‹› Always replace
7
Flexible disc
‹› Removing and installing, refer to --> [ Rear Driveshaft Flexible Disc ] See: Removal and Replacement/Rear Driveshaft Flexible Disc.
8
Washer
9
Bolt, 75 Nm
‹› Tighten bolt to specification while counter holding on nut --> [ (Item 6) Nut ].
10
Rear driveshaft
‹› Installation position: Colored marking on rear driveshaft must line up with colored marking on rear final drive.
‹› To avoid damaging boot in the vicinity of the center bearing - arrow -, rear driveshaft may only be flexed slightly.
11
Bolt, 30 Nm and turn 90° further
‹› Always replace.
12
Lock plate
13
Rear final drive
14
Bracket
‹› For center bearing.
15
Bolt, 20 Nm
‹› On bracket for rear driveshaft.
‹› To adjust driveshaft center bearing free of tension, loosen and tighten, refer to --> [ Rear Driveshaft Center Bearing ] See: Removal and
Replacement/Rear Driveshaft Center Bearing.
16
Bolt, 60 Nm
‹› Bracket to body.
17
Bolt
18
Nut, 75 Nm
‹› Always replace.