Touareg V10-5.0L DSL Turbo (BKW) (2004)
/Page-1615005.png)
Fault memories, erasing after "Update - Programming" (flashing)
Due to the CAN bus system, fault messages will be stored in various Control Modules during programming.
-
To erase ALL fault memories, confirm by selecting the forward arrow button.
Tip: This will take a few minutes, depending on how many control modules are accessed.
Once fault memories have been erased:
-
Similar screen appears.
-
Old Differential Control Module Part No. and software level still appear at (arrow).
-
Function ended appears at bottom of screen.
-
Finish update of the Differential Control Module by selecting the backward arrow button.
-
New update version software level" 0122" will appear at (arrow).
-
Print this screen to verify Differential Control Module software level.
-
Attach print to vehicle Repair Order.
-
Flash CD can now be removed from VAS 5051, VAS 5051 B, or VAS 5052 Diagnostic tool.
-
Select" Go to" then select" Exit".
-
Use VAS 5051, VAS 5051 B or VAS 5052 to set readiness code.
-
Test drive to ensure condition has been resolved.
Tip: Before replacing the differential motor or differential, contact the VW Helpline and observe the reporting obligation.
